Help Center

Contact Support
This site is not supported in Internet Explorer Compatibility mode. Please upgrade your browser or turn of compatibility mode.

How to remove and install the magazine extension on a Versa Max Tactical Shotgun

Overview

Instructions for the removal and installation of the magazine extension for the Versa Max Tactical Shotgun

To Disassemble the Magazine Extension:

  • Point the firearm in a safe direction.
  • Engage the Safety by placing the safety mechanism in the "ON" or "SAFE" position.  The Red Band Marking will NOT Be Visible.
  • Completely unload the firearm, see the To Unload Your Firearm section of your owner's manual.  With bolt open, look into the chamber and the ejection port and visually check the chamber, carrier and magazine to make sure no ammunition is present.
  • Unscrew and remove the tactical rail (5,6) from the barrel clamp assembly.
  • Loosen and remove the two barrel clamp screws (7), then remove the barrel clamps (8).

 

CAUTION: Use extreme care when removing the magazine tube extension, as it is under tension from the magazine spring.

  • Unscrew and remove the magazine tube extension (with the end cap attached) (1,4) from the magazine tube coupling (2).
  • Remove the magazine spring (3); do not remove the magazine follower.

To Assemble the Magazine Extension:

  • Point the firearm in a safe direction.
  • Engage the Safety by placing the safety mechanism in the "ON" or "SAFE" position.  The Red Band Marking will NOT Be Visible
  • Install magazine spring (3) into magazine tube.
  • Verify the firearm is completely unloaded.  With bolt open, look into the chamber and the ejection port and visually check the chamber, carrier and magazine to make sure no ammunition is present.  If ammunition is present, see the To Unload Your Firearm section of your owner's manual.
  • Install the magazine tube extension (with the end cap attached) (1,4) over the magazine spring (3) while using your fingers to depress coils of the magazine spring into the magazine tube extension.  Tighten magazine tube extension (1) into the magazine tube coupling (2).

 

Note: DO NOT TIGHTEN THE MAGAZINE TUBE EXCESSIVELY AS THIS MAY CAUSE SHELLS TO BIND IN THE TUBE.

  • Assemble barrel clamps (8) to the barrel and magazine tube extension (1), making sure to locate the barrel clamps in the recessed section of magazine tube extension (See Diagram).  See the Barrel Clamp Assembly figure below to properly orientate the clamp.  Insert the two barrel clamp screws (7) and tighten.

vm barrel clamp.PNG

 

  • Assemble the tactical rail (5) to the barrel clamp with the crew (6).
  • The swivel stud and tactical rail may be installed on either side.

 

vm tactical.PNG

Item No. Part Name
1 Magazine Tube Extension
2 Magazine Tube Coupling
3 Magazine Spring
4 Magazine Tube End Cap
5 Tactical Rail
6 Tactical Rail Screw
7 Barrel Clamp Screw (2)
8 Barrel Clamp (2)
9 Swivel Stud Spacer
10 Swivel Stud

 

Should you need parts for your Versa Max shotgun, please visit our online store at www.shopremingtoncountry.com.

You must to post a comment.