Help Center

Contact Support
This site is not supported in Internet Explorer Compatibility mode. Please upgrade your browser or turn of compatibility mode.

Operating the Firearm

Overview

Read detailed instructions about loading, unloading, and other operation of your Model 7400/750 firearm.

To Load the Firearm

I. TO LOAD ONE CARTRIDGE ONLY:

NOTE: The chamber should be cleaned before loading and firing the firearm the first time. Follow cleaning instructions shown in Cleaning, Lubrication, and Maintenance.

  1. Point the firearm in a safe direction.
  2. Engage the safety mechanism. RED BAND WILL NOT SHOW.
  3. Pull the operating handle fully rearward until the bolt is held open by the magazine follower.
  4. Put one cartridge of the correct caliber through the ejection port and into the chamber. See Picture 9.
    model7400_09.png
  5. Keep your fingers away from the ejection port and operating handle.
  6. Push the bolt release to close the action.

THE FIREARM IS NOW LOADED.

II. TO LOAD THE CHAMBER AND MAGAZINE:

  1. Point the firearm in a safe direction.
  2. Engage the safety mechanism. RED BAND WILL NOT SHOW.
  3. Pull the operating handle fully rearward until the action is held by the magazine follower.
  4. Put one cartridge of the correct caliber through the ejection port and into the chamber.
  5. Keep your fingers away from the ejection port and operating handle.
  6. Push the bolt release to close the action.
  7. Push the magazine latch forward and pull the magazine from the receiver.
  8. Push four cartridges of the correct caliber one at a time into the magazine. Keep the bullets aligned toward the chamber. See Picture 10.
    model7400_10.png
  9. Replace the magazine into the firearm.
  10. Make sure the magazine is fully latched into position.
    THE CHAMBER AND MAGAZINE ARE NOW FULLY LOADED.
  11. To fire the firearm, disengage the safety mechanism. RED BAND WILL SHOW.
    THE FIREARM IS READY TO FIRE.
  12. The firearm will fire each time the trigger is pulled until the magazine and chamber are empty.

WARNING: Always check the cartridge for the correct caliber before loading the firearm.

To Unload the Firearm

  1. Point the firearm in a safe direction.
  2. Engage the safety mechanism. RED BAND WILL NOT SHOW.
  3. Push the magazine latch forward and pull the magazine from the firearm.
  4. Pull the operating handle rearward to remove the cartridge from the chamber.
  5. Remove the cartridges from the magazine. See Picture 11.
    model7400_11.png
  6. Replace the magazine and open the action.

WARNING: Check the chamber and the magazine to make sure there are no cartridges in the firearm.

To Adjust the Sights

model7400_eye_icon.png

TO ADJUST THE REAR SIGHT:

For elevation (up and down adjustments) and windage (left and right adjustments), move the rear sight in the same direction as you need to move the bullet on the target. See Picture 12.

model7400_12.png

NOTE: For more information on ballistics and trajectory, see the REMINGTON® catalog.

TELESCOPIC SIGHTS:

The top of the receiver has holes for the installation of telescopic sights.

model7400_target.png

You must to post a comment.