Help Center

Contact Support
This site is not supported in Internet Explorer Compatibility mode. Please upgrade your browser or turn of compatibility mode.

The 30-06 CoreLokt® Ultra Bonded® load my Remington 2020® Digital Optic System is programmed for is no longer available. What do I do now?

Table of contents

Question

The 30-06 CoreLokt® Ultra Bonded® load my Remington 2020® Digital Optic System is programmed for is no longer available.  What do I do now?

Answer

 You have two options:

  1. Use standard 30-06 Sprg 180-gr CoreLokt ammunition and simply tell the system you are using the CoreLokt Ultra Bonded product.
  2. You can also use the new HyperSonic® Rifle 30-06 SPRG 180-gr ammunition, but this is a little more involved:
    1. Power the optic ON.
    2. Wait for the optic to completely boot – about 4 - 7 seconds.
    3. Press <MODE> once to switch the optic to advanced operating mode.
    4. Press AND HOLD <MODE> for about 7 – 10 seconds.  After 3-4 seconds, the “HUD Console” will appear – DO NOT RELEASE THE MODE BUTTON.  After an additional ~5 seconds, and “Advanced HUD Console” will appear.
    5. Using the zoom out button, go down through the list of items until you reach MUZZLE ADJUST.  Using the wind rocker, increment the velocity to < 130 FPS >.
    6. Press <MODE> to exit the HUD Console.
    7. Remember to set the ammunition type to CLK in the HUD Console!
    8. NOTE:  This setting will be saved (even through powering off and back on) and will apply to all ammunition types.  So if you switch the Barnes load, you will need to set it back to < 0 FPS >.

 

You must to post a comment.